Clamps and supports

Boss head supplied with two olives so that the clamp can fit on to support rods having diameters 8 14 mm. Stainless steel spring loaded centre arm holds burette firmly against the two outer arms and is protected by rubber grips. Graduations and meniscus are visible at all times. Suitable for all burettes.

Round bottomed flasks from the smallest up to 10 litres can be supported safely on the internal "steps" of this support. Hot flasks up to 100°C (120°C for short periods) can be supported without damage to the holder. Autoclavable.

Single or double holder for funnels as small as 25 mm (with adaptor supplied) and up to 170 mm. Without adaptor can be used with powder funnels with stem diameter not exceeding 35 mm. Two olives provided for use with rods from 8 to 14mm.

Horseshoe funnel holder especially for separating funnels. Supplied with two 'olives'so will fit supporting rod diameters 8 to 14 mm. Cannot be used with funnels below 75 mm diameter.
 

Rods can be screwed one into the other to obtain desired height. Each base is supplied with two rods.